FANUC Alarm MEMO-132 — WARN … has been broken
Warning- Hardware
- main board and memory
- Controllers
- R-J3iB / R-30iA
- FANUC class
- WARN
Manufacturer wording — WARN %s has been broken
The manual prints placeholders; your controller fills them in with the real group, axis or number.
FANUC MEMO-132 (“WARN … has been broken”): Program data has been broken at the power fail recover. First check: Delete the program and create it again.
Updated 2026-10-22 · LogrobotLM reference
Description
Program data has been broken at the power fail recover.
Remedy
Delete the program and create it again. Press the RESET key to clear the error. If the error is not cleared, document the events that led to the error and call your FANUC Robotics technical representative.
Field diagnosis
The data of the designated program was corrupted during recovery after a power failure.
What to check
- Delete the program and recreate it (or reload it from a backup), then reset.
- If the error persists, document it and contact support.
- Note: Regular backups to external media: this is where they pay off.
Related codes
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →