LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PAIN-252 — WARN Failed to find Lower limit

Description

Accustat could not reach the lower flow limit in the number of times set at the calibration screen. The lower limit flow rate can not be achieved. Fluid restricter is too large. The flow rate or the canister position feedback is unstable. : Verify all equipment is working properly . Check Color Data lower limit. Check applicator parameters to make sure that AppParameter Min limit is not abovethe AccuStat Color Data lower limit. Increase Auto cal hi/lowtolerance or Trys for high/low from the AccuStat setup screen. Check feedback.

Remedy · Remède

N/A

Related codes / Codes liés

PAIN-250WARN Auto Calibration abortedPAIN-251WARN Failed to find Upper limitPAIN-253WARN Beaker Timeout, Scale Cal AbortedPAIN-254WARN (%s) Non-increasing cal table

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.