LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PAIN-291 — WARN %s0 fluid flow rate timeout

Description

All of the conditions were set for fluid to be flowing and a zero flow rate was measured for longer than the Zero flow timeout parameter. This may be d by: a broken applicator trigger, a loss of fluid supply pressure, a broken fluid flow meter, a broken cable (to the flow meter), or a Zero flow timeout value that is too short. Note, AccuFlow temporarily automatically changes to Open Loop when this alarm occurs.

Remedy · Remède

Check that the gun is properly triggering. If fluid was observed to be flowing, check and possibly replace the fluid flow meter. Possibly increase the Zero flow timeout parameter (by about 25%).

Related codes / Codes liés

PAIN-289WARN %sFailed to reach setpointPAIN-290WARN %sAccuflow softpart init failedPAIN-292WARN %sMax. flow below mid pointPAIN-316WARN HookUp confirmation failed

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.