FANUC Alarm PAIN-530 — WARN …Cal. table adapted out,output up
Manufacturer wording — WARN %sCal. table adapted out,output up
The manual prints placeholders; your controller fills them in with the real group, axis or number.
FANUC PAIN-530 (“WARN …Cal. table adapted out,output up”): The relationship of the output command to the flow rate obtained has changed significantly First check: Check, clean and possibly replace the air cap. Likely part: Air cap (Air cap (paint atomizer)).
Updated 2026-09-17 · LogrobotLM reference
Description
The relationship of the output command to the flow rate obtained has changed significantly
Remedy
Check, clean and possibly replace the air cap. Check for a large loss of air supply pressure. Check for pinched air lines or clogged air passages in the gun. Recalibrate to immediately clear the alarm. Increase the Adaptive tolerance parameter to allow larger changes without alarming
Part to check / replace
FANUC PAIN-530 points to the hardware below — start here before ordering.
Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.
Related codes
Same hardware involved
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →