LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT1-577 — CH1:Dyn. yield > tolerance band (%s)

Description

As a particular flow rate set point is being output, the yield ((cc/min)/cnt) for that flow rate was larger than the tolerance band for it. It is not likely that the set point will be reached. This might be due to the restricters in the gun being too large.

Remedy · Remède

Decrease the yield. Use smaller restrictors in the gun if the high end flow rate can still obtained. Otherwise, accept a larger tolerance band. If the value given in the alarm is equal to the Minimum tolerance band, set the minimum tolerance band equal to the yield for that color. Otherwise, increase the Percent tolerance band.

Related codes / Codes liés

PNT1-575%s0 fluid flow rate timeoutPNT1-576%sMax. flow below mid pointPNT1-583%sCal. table adapted out tolerancePNT1-584%sCal. table adapted in tolerance

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.