LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT1-595 — %sTime out during a cal. test

Description

While measuring hysteresis time up or time down, the Accuflow system timed out. This indicates that the high or low flow rate could not be reached.

Remedy · Remède

Retry the calibration. Check that the high flow rate can be reached consistantly. If not, an increase in the Tolerance band might be required.

Related codes / Codes liés

PNT1-593%sZero fluid flow rate detectedPNT1-594%sLower output did not lower flowPNT1-596%sMin. output has flow > setpointPNT1-597%sMax. output has flow < setpoint

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.