LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT1-593 — %sZero fluid flow rate detected

Description

All of the conditions were set for fluid to be flowing however, a zero flow rate was measured. This might be due to no fluid pressure or pilot air pressure. With a very low flow rate, the gain might be too high. One of the following items might be broken:

Remedy · Remède

If fluid can be seen coming from the applicator, check the following:

Related codes / Codes liés

PNT1-591%sCal. time out at max. flowPNT1-592%sCal. time out at low flowPNT1-594%sLower output did not lower flowPNT1-595%sTime out during a cal. test

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.