LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT1-831 — PNT1-831

Manufacturer wording — %s
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PNT1-831 (“PNT1-831”): An attempt was made to extend or retract the pusher at SpeedDock side A or B, but the attempt failed. First check: Check the retract or extend sensor at SpeedDock side A or B.

Updated 2026-09-17 · LogrobotLM reference

Description

An attempt was made to extend or retract the pusher at SpeedDock side A or B, but the attempt failed.

Remedy

Check the retract or extend sensor at SpeedDock side A or B. Ensure that the pusher retracted or extended fully at SpeedDock side A or B. Ensure that sufficient air pressure is available for this operation and that the air lines are connected.

Related codes

PNT1-829HIGH SpeedDock TORQUEPNT1-830SpeedDock motor not readyPNT1-832PNT1-833HIGH ServoBell TORQUE

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →