LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT2-248 — %s0 gls feed rate T.O.

Description

All of the conditions were set for glass to be feeding and a zero feed rate was measured. This might be caused by:

Remedy · Remède

If the glass is not feeding from the chopper motor, check the items listed above or the 32 point input module. If it occurs with very low feed rates, decrease the Normal gain modifier in Accuchop's Glass Setup screen.

Related codes / Codes liés

PNT2-246%sMax output has flow < setpointPNT2-247%sMin output has flow > setpointPNT2-249%sMax output has feed < setpointPNT2-250%sMin output has feed > setpoint

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.