LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT2-562 — %sCal. time out at max. flow

Description

Accuflow timed out trying to reach the maximum flow rate. Possible causes are: a high gain, a sticking I/P transducer, a bad fluid regulator or frequent fluid pressure changes.

Remedy · Remède

Possibly decrease the Gain modifier used for the color. Retry the calibration. Check and change the transducer if necessary, and replace the fluid regulator or service the surge suppression system on the fluid supply pump. The calibration timeout parameter can be increased.

Related codes / Codes liés

PNT2-560%sCal. low flow rate resetPNT2-561%sCal. max. flow rate resetPNT2-563%sCal. time out at low flowPNT2-564%sZero fluid flow rate detected

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.