LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PAIN-278 — WARN …Cal. time out at max. flow

Manufacturer wording — WARN %sCal. time out at max. flow
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PAIN-278 (“WARN …Cal. time out at max. flow”): Accuflow timed out trying to reach the maximum flow rate. First check: Possibly decrease the Gain modifier used for the color. Likely part: Fluid regulator (Fluid regulator).

Updated 2026-09-17 · LogrobotLM reference

Description

Accuflow timed out trying to reach the maximum flow rate. Possible s are: a high gain, a sticking I/P transducer, a bad fluid regulator or frequent fluid pressure changes.

Remedy

Possibly decrease the Gain modifier used for the color. Retry the calibration. Check and change the transducer if necessary, replace the fluid regulator or service the surge suppression system on the fluid supply pump. The calibration timeout parameter can be increased.

Part to check / replace

FANUC PAIN-278 points to the hardware below — start here before ordering.

Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.

Related codes

PAIN-276WARN …Cal. low flow rate resetPAIN-277WARN …Cal. max. flow rate resetPAIN-279WARN …Cal. time out at low flowPAIN-280WARN …Zero fluid flow rate detected

Same hardware involved

PAIN-273Fluid regulatorPAIN-283Fluid regulatorPAIN-433Fluid regulatorPAIN-438Fluid regulator

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →