LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT2-614 — Dyn. yield > % tolerance band

Manufacturer wording — %sDyn. yield > % tolerance band
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PNT2-614 (“Dyn. yield > % tolerance band”): The scale calibration sequence did not complete. First check: Check the alarm log to see what conditions caused the calibration to abort.

Updated 2026-09-17 · LogrobotLM reference

Description

The scale calibration sequence did not complete. This can be caused by a timeout or fill/empty error.

Remedy

Check the alarm log to see what conditions caused the calibration to abort. In most cases, the scale cal can timeout from one of the following alarms: PNT1-253 Beaker timeout, scale cal abort, PNT1-248, CC abort, can full timeout, PNT1-249 CC abort, can empty timeout. Verify all equipment is operating properly.

Related codes

PNT2-612Cal. table adapted out,output upPNT2-613Cal. table adapted in tolerancePNT2-615Flow rate avg. error excessivePNT2-616Calibration successful

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →