LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT2-665 — %sDyn. yield > min tolerance band

Description

As a particular flow rate set point is being output the yield (slpm/cnt) for that flow rate was approximately larger than the percent tolerance. It is not likely that the set point will be reached within the specified tolerances. This might be caused by the use of a flow rate setpoint that is below the value that the air system can accurately provide.

Remedy · Remède

In some way decrease the yield. Use larger diameter air lines to supply air to the cap. Use a smaller ratio booster. Otherwise accept a larger tolerance band. Increase the minimum tolerance (by about 50%).

Related codes / Codes liés

PNT2-663%s0 air flow rate timeoutPNT2-664%sWarning, learn item failedPNT2-666%sCal. table adapted out, downPNT2-667%sMax. flow is below midpt. output

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.