LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT2-908 — Zero Flow Programmed: %s

FANUC PNT2-908 (“Zero Flow Programmed: %s”): Zero Flow was programmed in CC. First check: Ensure that a flow rate is setup in the CC preset data.

Updated 2026-08-29 · LogrobotLM reference

Description

Zero Flow was programmed in CC.

Remedy · Remède

Ensure that a flow rate is setup in the CC preset data.

Frequently asked · Questions fréquentes

What does FANUC alarm PNT2-908 mean?
FANUC PNT2-908 (“Zero Flow Programmed: %s”): Zero Flow was programmed in CC.
How do you troubleshoot FANUC alarm PNT2-908?
Ensure that a flow rate is setup in the CC preset data.

Related codes / Codes liés

PNT2-906Low can Pressure after Fill: %sPNT2-907Canister Dir - extending: %sPNT2-909%sHIGH Negative Canister TORQUEPNT2-910%sHIGH Positive Canister TORQUE

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique. How this reference is built →