LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SEAL-268 — WARN Flow rate is zero (E…)

Manufacturer wording — WARN Flow rate is zero (E%d)
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC SEAL-268 (“WARN Flow rate is zero (E…)”): This error is reported when the process mode is wet and the computed flow rate is equal to zero. First check: Refer to dispensing equipment for fault details.

Updated 2026-09-17 · LogrobotLM reference

Description

This error is reported when the process mode is wet and the computed flow rate is equal to zero.

Remedy

Refer to dispensing equipment for fault details.

Related codes

SEAL-266WARN Minor Dispenser Fault on (E…)SEAL-267STOP Volume dispensed out of range (E…)SEAL-269WARN Flow command below set point (E…)SEAL-270WARN Flow command above set point (E…)

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →