LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm SPOT-002 — PAUSE Iso contactor fault %s

Description

The isolation contactor on the specified weld controller is in a fault condition. If no program is running, then this message is posted if either the Iso contactor output is high or the Iso contactor input is high. If a program is running, or a manual weld is being executed, then the output, if defined, must be high, and the input, if defined, must be high too.

Remedy · Remède

Make sure that the CLOSE CONTACTOR macro instruction has been programmed in the teach pendant program.

Related codes / Codes liés

SPOT-000WARN Unknown error (SWG0)SPOT-001PAUSE Backup not closed %sSPOT-003PAUSE Water saver OK fault %sSPOT-004PAUSE Water flow OK fault %s

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.