LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SPOT-035 — PAUSE Invalid equipment (… defined)

Manufacturer wording — PAUSE Invalid equipment (%s defined)
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC SPOT-035 (“PAUSE Invalid equipment (… defined)”): An invalid equipment number was specified. First check: The current number of equipments that the system is configured for is displayed in the error message.

Updated 2026-09-17 · LogrobotLM reference

Description

An invalid equipment number was specified.

Remedy

The current number of equipments that the system is configured for is displayed in the error message. Only use the value one up to and including the number posted on the error line. If you need to increase the number of equipment, then perform an INIT start (backup all files first), and enter the new number of equipment when prompted during the SETUP APPLICATION menu

Related codes

SPOT-033PAUSE Backup open fault …SPOT-034PAUSE Backup close fault …SPOT-036PAUSE Invalid weld controller (… defined)SPOT-037WARN No gun contactors defined

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →