LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm SPOT-036 — PAUSE Invalid weld controller (%s defined)

Description

An invalid weld controller number was specified.

Remedy · Remède

The current number of weld controllers that the system is configured for is displayed in the error message. Only use the value one up to and including the number posted on the error line. If you need to increase the number of weld controllers, then perform a controlled start, and define the new number of weld controllers when prompted during the SETUP APPLICATION menu

Related codes / Codes liés

SPOT-034PAUSE Backup close fault %sSPOT-035PAUSE Invalid equipment (%s defined)SPOT-037WARN No gun contactors definedSPOT-038WARN Stud feeders low

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.