LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SPOT-076 — PAUSE Weld enable mismatch-gun 1

FANUC SPOT-076 (“PAUSE Weld enable mismatch-gun 1”): The weld enable status from the weld controller does not match the robot’s weld enable status. First check: Check the robot’s weld enable status on the TEST CYCLE menu and compare it to the

Updated 2026-09-17 · LogrobotLM reference

Description

The weld enable status from the weld controller does not match the robot’s weld enable status.

Remedy

Check the robot’s weld enable status on the TEST CYCLE menu and compare it to the

Related codes

SPOT-074PAUSE Water flow fault-gun 1SPOT-075PAUSE X-former fault-gun 1SPOT-077PAUSE Weld in process timeout-gun 1SPOT-078PAUSE Weld complete timeout-gun 1

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →