FANUC Alarm SPOT-384 — IWC(DG) leak input (%d)

FANUC SPOT-384 (“IWC(DG) leak input (%d)”): The Leak Input signal is on. First check: 1. Remove the cause of the leak.

Updated 2026-08-29 · LogrobotLM reference

Description

The Leak Input signal is on.

Remedy · Remède

1. Remove the cause of the leak. 2. Refer to the Weld Interface I/O screen and verify that the Leak Input signal is OFF. Using the teach pendant: - a. Press I/O. - b. Press F1, [TYPE]. - c. Select Spot Equip.

Frequently asked · Questions fréquentes

What does FANUC alarm SPOT-384 mean?: FANUC SPOT-384 (“IWC(DG) leak input (%d)”): The Leak Input signal is on.
How do you troubleshoot FANUC alarm SPOT-384?: 1. Remove the cause of the leak. 2. Refer to the Weld Interface I/O screen and verify that the Leak Input signal is OFF. Using the teach pendant: - a. Press I/O. - b. Press F1, [TYPE]. - c. Select Spot Equip.

Related codes / Codes liés

SPOT-381IWC(DG) system error(%d)SPOT-382PAUSE IWC(DG) illegal stepper number(%s)SPOT-385PAUSE IWC(DG) illegal counter specified(%s)SPOT-386PAUSE Reset stepper timeout %s

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique. How this reference is built →