LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SPOT-386 — PAUSE Reset stepper timeout …

Manufacturer wording — PAUSE Reset stepper timeout %s
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC SPOT-386 (“PAUSE Reset stepper timeout …”): The weld controller did not acknowledge the reset stepper command in the alloted time. First check: Check that the weld controller is functioning correctly.

Updated 2026-09-17 · LogrobotLM reference

Description

The weld controller did not acknowledge the reset stepper command in the alloted time.

Remedy

Check that the weld controller is functioning correctly.

Related codes

SPOT-384IWC(DG) leak inputSPOT-385PAUSE IWC(DG) illegal counter specifiedSPOT-397Studwelding resume not allowedSPOT-399IWC FIRMWARE UPGRADED

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →