LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm SVGN-068 — Could not load program %s

FANUC SVGN-068 (“Could not load program %s”): The teach pendant program for tip wear measurement could not be loaded. First check: Resume the program, to re-attempt the load.

Updated 2026-08-29 · LogrobotLM reference

Description

The teach pendant program for tip wear measurement could not be loaded. See cause code for reason.

Remedy · Remède

Resume the program, to re-attempt the load. If the load is successful, then the tip wear measurement will continue.

Frequently asked · Questions fréquentes

What does FANUC alarm SVGN-068 mean?
FANUC SVGN-068 (“Could not load program %s”): The teach pendant program for tip wear measurement could not be loaded. See cause code for reason.
How do you troubleshoot FANUC alarm SVGN-068?
Resume the program, to re-attempt the load. If the load is successful, then the tip wear measurement will continue.

Related codes / Codes liés

SVGN-066Manual Weld Verif. ActivatedSVGN-067Manual Weld Verif. De-ActivatedSVGN-069Pressure position is near close limit.SVGN-070PAUSE Gun Change is DISABLED.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique. How this reference is built →