ABB Error 33148 — Axis computer fault
ErrorABB 33148 (“Axis computer fault”): The DSP processor of the axis computer was stopped by a hardware interrupt following a miscellaneous error. Likely part: Axis computer (Axis computer).
Updated 2026-10-22 · LogrobotLM reference
What it means
The DSP processor of the axis computer was stopped by a hardware interrupt following a miscellaneous error.
What to check
- Check the axis computer board.
- Replace the robot control board.
- Note: Will become the damaged or not found axis computer error (32574, 32575) on IRC5.
Part to check / replace
ABB 33148 points to the hardware below — start here before ordering.
Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.
Related codes
Same hardware involved
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →