FANUC Alarm CVIS-210 — The calibration points are too close to each other.
FANUC CVIS-210 (“The calibration points are too close to each other.”): The robot position is needed when the fixture is mounted on a robot. First check: Snap the image from a camera to use a real-world image.
Updated 2026-08-29 · LogrobotLM reference
Description
The robot position is needed when the fixture is mounted on a robot. However, the robot position is not set. This alarm might occur when you are using an image loaded from a file.
Remedy · Remède
Snap the image from a camera to use a real-world image.
Frequently asked · Questions fréquentes
- What does FANUC alarm CVIS-210 mean?
- FANUC CVIS-210 (“The calibration points are too close to each other.”): The robot position is needed when the fixture is mounted on a robot. However, the robot position is not set. This alarm might occur when you are using an image loaded from a file.
- How do you troubleshoot FANUC alarm CVIS-210?
- Snap the image from a camera to use a real-world image.
Related codes / Codes liés
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique. How this reference is built →