LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm CVIS-211 — The calibration points are too close to each other.

FANUC CVIS-211 (“The calibration points are too close to each other.”): The plane specified in the CAMERA_CALIB is disabled. First check: Enable the calibration plane, or pass another index to the CAMERA_CALIB.

Updated 2026-09-17 · LogrobotLM reference

Description

The plane specified in the CAMERA_CALIB is disabled.

Remedy

Enable the calibration plane, or pass another index to the CAMERA_CALIB.

Related codes

CVIS-209The calibration points are too close to each other.CVIS-210The calibration points are too close to each other.CVIS-212No robot position for robot mounted camera.CVIS-213Robot positions for two points must be the same.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →