FANUC Alarm PNT1-560 — Cal. low flow rate reset
Manufacturer wording — %sCal. low flow rate reset
The manual prints placeholders; your controller fills them in with the real group, axis or number.
FANUC PNT1-560 (“Cal. low flow rate reset”): The low flow rate could not be reached during Accuflow calibration. First check: Decrease the Gain modifier used for the color, if possible.
Updated 2026-09-17 · LogrobotLM reference
Description
The low flow rate could not be reached during Accuflow calibration. A new low flow rate was established.
Remedy
Decrease the Gain modifier used for the color, if possible. The new low flow rate is shown as point 2 in the calibration table. This value can be visually checked and accepted.
Related codes
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →