LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT1-562 — Cal. time out at max. flow

Manufacturer wording — %sCal. time out at max. flow
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PNT1-562 (“Cal. time out at max. flow”): Accuflow timed out trying to reach the maximum flow rate. First check: Try the following:

Updated 2026-09-17 · LogrobotLM reference

Description

Accuflow timed out trying to reach the maximum flow rate. The possible causes are:

Remedy

Try the following:

Related codes

PNT1-560Cal. low flow rate resetPNT1-561Cal. max. flow rate resetPNT1-563Cal. time out at low flowPNT1-564Zero fluid flow rate detected

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →