LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT1-563 — Cal. time out at low flow

Manufacturer wording — %sCal. time out at low flow
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PNT1-563 (“Cal. time out at low flow”): Accuflow timed out trying to reach the loweset flow rate, typically 100 cc/min. First check: Try the following:

Updated 2026-09-17 · LogrobotLM reference

Description

Accuflow timed out trying to reach the loweset flow rate, typically 100 cc/min. Possible causes are:

Remedy

Try the following:

Related codes

PNT1-561Cal. max. flow rate resetPNT1-562Cal. time out at max. flowPNT1-564Zero fluid flow rate detectedPNT1-565Lower output did not lower flow

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →