LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT1-702 — Requested speed over valid range

Manufacturer wording — %sRequested speed over valid range
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PNT1-702 (“Requested speed over valid range”): The requested turbine speed output command is above the range that is considered valid Adjust the turbine speed command that is used in the preset table so it is within an acceptable range. First check: N/A

Updated 2026-09-17 · LogrobotLM reference

Description

The requested turbine speed output command is above the range that is considered valid Adjust the turbine speed command that is used in the preset table so it is within an acceptable range.

Remedy

N/A

Related codes

PNT1-700Max.dV/dT detectedPNT1-701Max. output has speed < setpointPNT1-703Failed to reach setpointPNT1-704Zero turbine speed timeout

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →