LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT1-716 — Turbine Startup Test Not Complete

Manufacturer wording — %sTurbine Startup Test Not Complete
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PNT1-716 (“Turbine Startup Test Not Complete”): The Bell Speed Control Startup Test for the turbine is not complete. First check: Check the Start Mode field on the Bell Speed SETUP menu to check the status of the Startup Test.

Updated 2026-09-17 · LogrobotLM reference

Description

The Bell Speed Control Startup Test for the turbine is not complete. This test must be performed before running the turbine.

Remedy

Check the Start Mode field on the Bell Speed SETUP menu to check the status of the Startup Test. If it has not been performed, run the Bell Speed Control Startup Test.

Related codes

PNT1-709Bearing Air NOT OKPNT1-710Cruise Speed not establishedPNT1-717Max.dV/dT detectedPNT1-718Max. output has speed < setpoint

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →