LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT1-718 — %sMax. output has speed < setpoint

Description

With a maximum control output the speed was measured to be lower than the setpoint (requested speed). The gun might be clogging. The turbine air or turbine pilot air line might be pinched. The turbine air pressure might have become too low.

Remedy · Remède

Check the turbine lines for pinching, especially at places where they flex. Check the turbine air supply pressure. Check and replace the I/P transducer if necessary.

Related codes / Codes liés

PNT1-716%sTurbine Startup Test Not CompletePNT1-717%sMax.dV/dT detectedPNT1-719%sRequested speed over valid rangePNT1-720%sFailed to reach setpoint

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.