LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT2-176 — Calculated output > Max Output

FANUC PNT2-176 (“Calculated output > Max Output”): The calculated command counts are above the Applicator Parameter Maximum Output value (1000 counts, or 8000 counts hires). First check: Determine what is limiting the flow rate.

Updated 2026-09-17 · LogrobotLM reference

Description

The calculated command counts are above the Applicator Parameter Maximum Output value (1000 counts, or 8000 counts hires). Fluid restrictor is too small or the regulator is not working properly.

Remedy

Determine what is limiting the flow rate. Check the Color Data Hi/Low flow range settings. PNT1- 256, Calculated output < min output.

Related codes

PNT2-174Beaker Timeout, Scale Cal AbortedPNT2-175Non-increasing cal tablePNT2-177Calculated output < Min OutputPNT2-178Failed to reach setpoint

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →