LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT2-567 — %sMin. output has flow > setpoint

FANUC PNT2-567 (“%sMin. output has flow > setpoint”): With a minimum control output the flow rate was measured to be higher than the setpoint (requested flow). First check: Calibrating the color will establish a new cracking pressure (minimum control output) for a changed fluid pressure. Likely part: Transducer (Transducer) +1 more.

Updated 2026-08-29 · LogrobotLM reference

Description

With a minimum control output the flow rate was measured to be higher than the setpoint (requested flow). The fluid pressure might have become too high. The I/P transducer or fluid regulator might be stuck open. There might be a fairly large fluid leak. Note, Accuflow automatically changes to Open Loop when this failure occurs.

Remedy · Remède

Calibrating the color will establish a new cracking pressure (minimum control output) for a changed fluid pressure. Check and replace if necessary the fluid regulator and I/P transducer. See the Fluid flow leak alarms for other options.

Part to check / replace · Pièce à contrôler / remplacer

FANUC PNT2-567 points to the hardware below — start here before ordering. · PNT2-567 met en cause l'organe ci-dessous : commencez par là.

Tap a part for every code that points to it — and verify the exact variant for your controller before ordering. · Touchez une pièce pour tous les codes qui la citent ; vérifiez la variante exacte avant commande.

Frequently asked · Questions fréquentes

What does FANUC alarm PNT2-567 mean?
FANUC PNT2-567 (“%sMin. output has flow > setpoint”): With a minimum control output the flow rate was measured to be higher than the setpoint (requested flow). The fluid pressure might have become too high. The I/P transducer or fluid regulator might be stuck open. There might be a fairly large fluid leak. Note,…
How do you troubleshoot FANUC alarm PNT2-567?
Calibrating the color will establish a new cracking pressure (minimum control output) for a changed fluid pressure. Check and replace if necessary the fluid regulator and I/P transducer. See the Fluid flow leak alarms for other options.
Which part is involved in FANUC PNT2-567?
PNT2-567 points to Transducer (Transducer), Fluid regulator (Fluid regulator). Confirm the real cause against the robot backup before replacing a part.

Related codes / Codes liés

PNT2-565%sLower output did not lower flowPNT2-566%sTime out during a cal. testPNT2-568%sMax. output has flow < setpointPNT2-569%sFlow setpoint below globals

Same hardware involved / Même matériel en cause

PAIN-273Fluid regulatorPAIN-278Fluid regulatorPAIN-279Fluid regulatorPAIN-283Fluid regulator

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique. How this reference is built →