LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PRIO-014 — WARN Analog input sequnce too long

FANUC PRIO-014 (“WARN Analog input sequnce too long”): The specified analog input sequence is too long; sequences must have from 1 to 15 ports numbers. First check: Supply a sequence of an appropriate length.

Updated 2026-09-17 · LogrobotLM reference

Description

The specified analog input sequence is too long; sequences must have from 1 to 15 ports numbers.

Remedy

Supply a sequence of an appropriate length.

Related codes

PRIO-012WARN Bad board addressPRIO-013WARN No analog input sequence for bdPRIO-017WARN I/O point not simulatedPRIO-020STOP I/O Link comm error …, …, …, … (hex)

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →