FANUC Alarm PNT1-248 — 0 gls feed rate T.O.
Manufacturer wording — %s0 gls feed rate T.O.
The manual prints placeholders; your controller fills them in with the real group, axis or number.
FANUC PNT1-248 (“0 gls feed rate T.O.”): All of the conditions were set for glass to be feeding, however a zero feed rate was measured. First check: If the glass is not feeding from the chopper motor, check the items listed above or the 32 point input module.
Updated 2026-09-17 · LogrobotLM reference
Description
All of the conditions were set for glass to be feeding, however a zero feed rate was measured. This might be caused by:
Remedy
If the glass is not feeding from the chopper motor, check the items listed above or the 32 point input module. If it occurs with very low feed rates, decrease the Normal gain modifier in Accuchop's Glass SETUP screen.
Related codes
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →