LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SVGN-218 — This press can't be compensated

FANUC SVGN-218 (“This press can't be compensated”): Because this command pressure was lower than the value of WT compensation press low lim of Servo Gun General Setup screen, this command pressure was not able to be compensated. First check: Confirm the value of WT compn press low lim of the Servo Gun General Setup screen.

Updated 2026-09-17 · LogrobotLM reference

Description

Because this command pressure was lower than the value of WT compensation press low lim of Servo Gun General Setup screen, this command pressure was not able to be compensated.

Remedy

Confirm the value of WT compn press low lim of the Servo Gun General Setup screen.

Related codes

SVGN-216Illegal wt compens val: Gun…,P…SVGN-217Do press calib over againSVGN-219Angle is wrongSVGN-220Set value is wrong

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →