KUKA Hardware error codes
43 codes · Full list — meaning and checks.
116DSE COMMAND WITHOUT RESPONSE <PV--NR>200WAITING FOR SERVO POWER-UP224POWER FAILURE1000USER MEMORY LOST (**)1005NO MORE SYSTEM MEMORY AVAILABLE1006USER MEMORY NOT AVAILABLE1077ACKNOWLEDGE TOO MANY DEVICES ON THE SERVO BUS1080ACKNOWLEDGE: DSE POWER BUS CONFIGURATION1122ANALOG OUTPUTS -- DELAY REDUCTION1125ELECTRONIC PROBE FAULT1160TRACE: RECORDING TIME TOO LONG1214POWER FAILURE1228KPS600 / ballast resistor1301PROCEDURE ERROR1306DEVICE NOT READY FOR OPERATION1307FORMAT ERROR1403INTERRUPT COMMAND ABORTED1484ADHESIVE PRESSURE ERROR1486OIL TEMPERATURE TOO HIGH1487LINE AIR PRESSURE1489CENTERING ERROR1514INSERT THE NEXT FLOPPY DISK1562<SINEC L2, SINEC H1> BOARD NOT AVAILABLE1567NO CONNECTION ON THE SINEC L2 BOARD1597NO DSE AXIS2029SYNTAX ERROR IN THE MODULE2030SYNTAX ERROR IN THE MODULE THE MODULE IS OC-2031MODULE NOT AVAILABLE2051NAME IN LINE 1 MUST BE THE MODULE NAME2209MEMORY SPACE FOR DYNAMIC VARIABLE TOO LARGE2318PARAMETERS MUST BE DECLARED IN THE MODULEKSS00126Servo drive (KSD/KSP) + mechanical drive train of the axisKSS01146Motor / axis brake / servo driveKSS01305KSP servo drive / DC link (KPP power supply)KSS12014External fan of the controller cabinetKSS13012EtherCAT bus SYS-X44 / CCUKSS15073Drive safety node (KSP) / motor cableKSS15074Drive safety node (KSP), second channelKSS26015KPP power supplyKSS26118KPPKSS26130KPP / intermediate circuit (DC link)KSS26152KPP (KPP0) / mains power supplyKSS26233KPP / DC link